1:Yes, this can be done, but you need a router to route between the 5 vlans
2: Yes, you should set the speed on switch B to the same speed as switch a
(100Mbps Half duplex)
Taco Hettema
CCDP CCNP
-----Original Message-----
From: Crash [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, November 08, 2000 12:23 PM
To: [EMAIL PROTECTED]
Subject: Switching question's
Need a suggestion.
1. Can this be done.. logically segment the network by assigning VLANs to
the switch ports that the 5 hubs (existing hardware) are connected to a
switch. Cost is also an issue here.
2. Switch A, port speed can only be set to half duplex for either 10 or 100
Mbps, a known issue with this particular hardware and the client is not able
to change it even with the manufacturers recommendation. Switch B, is a new
switch that is configurable to go half or full duplex on the port speed.
Switch B is uplinked to switch A. Switch B's port speed is set at 100 Full
duplex with autonegotiation turned off. The connectivity is slow, should
the port speed on switch B change to half duplex as it is on switch A until
the problem with the port speed on switch A is fixed.
--
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
