Glad to help... see below for config examples...
<[EMAIL PROTECTED]> wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
>
> I am trying to configure 5 Cisco router's with appletalk, can someone
out
> their send me a complete config list?
Sure...
hostname R1 <- change for your hostname
!
bridge irb <- for Appletalk to work on Frame
appletalk routing <- to route Appletalk
!
enable secret apassword <- change to your own password
!
interface s0
encapsulation frame-relay <- for Frame-Relay
ip add x.x.x.x m.m.m.m <- insert your IP address
frame-relay interface dlci 123 <- insert your DLCIs
frame-relay interface dlci 234 <- if more than one, each must be seperate
bridge-group 1 <- enables Appletalk
!
interface e0
ip add x.x.x.x m.m.m.m <- insert your IP address
bridge-group 1 <- enables Appletalk
!
bridge 1 route ip <- for IP to work
no bridge 1 bridge ip <- so IP and Appletalk don't conflict
bridge 1 bridge appletalk <- ties Appletalk config together
bridge 1 protocol ieee <- bridge protocol for Appletalk (sounds just like
iMac too!)
!
line con 0
no exec <- safety measure/better security, must supply enable password for
access
!
line aux 0
no exec <- safety measure/better security, must supply enable password for
access
!
line vty 0 4
no login <- safety measure/better security so no one can login from
Internet!
privilege level 15 <- specifies dumb mode, level 1 gives you
everything/enable access
You can cut and past the whole configs and modify for each router (just
remember to remove the comments and put in your own IP addresses and DLCIs).
If you don't know what DLCI to use, ask your provider.
;-)
Regards,
Adrian
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
