RE: Router with Web Cache Engine

Tue, 21 Nov 2000 19:25:53 -0800

Use IP WCCP WEB-CACHE. That will enable cache discovery globally. You must then use IP WCCP REDIRECT-OUT on the interface connected to your cache server's segment.
 
You may need to use IP WCCP WEB-CACHE REDIRECT-LIST XXX (where XXX is access-list #) globally to filter specific IP's that should NOT be redirected.
 
Regards,
Eric Sineath
CCIE (R/S & Design) #4504
Senior Consultant
SBC DataComm
-----Original Message-----
From: Minh Vu [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, November 21, 2000 6:22 PM
To: Tim Schlosser; [EMAIL PROTECTED]
Subject: Re: Router with Web Cache Engine

I'm running Enterprise version 12.1 and 11.3 which I believe they will have the "ip wccp enable". According Cisco document, they said "ip wccp enable" was implemented on 11.2 and later, but they didn't mention which hardware will supported..
----- Original Message -----
Sent: Tuesday, November 21, 2000 3:06 PM
Subject: Re: Router with Web Cache Engine

12.07T has the wccp code enabled.  I believe you need the T train, and at a minimum of 12.04T
----- Original Message -----
From: Minh Vu
Sent: Tuesday, November 21, 2000 11:09 AM
Subject: Router with Web Cache Engine

Hi,
 
Anyone know which IOS (ie: IP, Enterprise, FW, etc...) support the Web Cache Engine ? I tried to find the command on my router but I couldn't find it on Cisco 1005 and 2501 with Enterprise feature set. 
I did went thru cisco document site.
and here
 
they said type in command in global configuration mode: ip wccp
but when I tried on those two routers it was unknown command.
 
Anyone have any hint?
 
Thanks

Reply via email to