Use IP Policy Routing on the RSM to set the next hop for specific users. For
instance, if the users are on subnets 10.10.1.0/24 and 10.10.2.0/24, you
could use:
access-list 1 permit ip 10.10.1.0 0.0.0.255
access-list 1 permit ip 10.10.2.0 0.0.0.255
interface vlan40
ip policy route-map OLDNET
ip local policy route-map OLDNET
route-map OLDNET permit 10
match ip address 1
set ip next-hop 10.1.1.1
Regards,
Eric Sineath
CCIE (R/S & Design)
Senior Consultant
SBC DataComm
-----Original Message-----
From: Michael Fountain [mailto:[EMAIL PROTECTED]]
Sent: Monday, November 27, 2000 3:15 PM
To: [EMAIL PROTECTED]
Subject: Source Routing
Kind of a bizarre situation, but...
We have a large, productional network that can't be messed with too much.
Basic network could be looked at like this
<old inet router> - core(5500rsm) - distro(4700) - access(1720s)
/
<new inet router> ---/
What we need to be able to to do is route a couple of the customers on the
1720s towards the new internet connection until we are ready to swing
everyone over to it.
Since we already have a default route to the existing internet connection,
what is the easiest way to do this?
I've considered creating tunnels between the 1720s and the new internet
routers, but have always heard things about tunnels and CPU usage. It is an
ethernet environment only, so I don't know of any way to source route.
Any suggestions?
____________________________________________________________________________
_________
Get more from the Web. FREE MSN Explorer download : http://explorer.msn.com
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
