Hi Guys,
I have a question for you. In my organitation there is the request to
create two NAT pool address in the same router, in specific CISCO 3640, for
two serial interface connect two different sites.
In particulary, the hosts with IP Class 13.12.1.0 with subnet mask
255.255.255.0 must two other site with IP class
10.12.68.0 and 130.12.13.0 both with subnet mask 255.255.255.0.
A statement these IP address Class belong an other Organitazion but they
exist in my organitazion for this
motive i shaped the NAT.
In this moment in my router is configured un NAT Pool address for a site, i
must configure a new NAT pool address for the new site.
My question is:
If i make the two NAT pool address, the configuration for the two interface
( inbound and outbound , etc . etc.) and I add the relative static route
for the two Pool address, well , the routing of the different packets for
two different sites is it correct ?
Best Reagrds, Carmelo
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
