If you look at the interface input stats for s0 there
are input errors, CRC errors, framing errors,
overruns, etc. Clear the counters if this has been up
awhile, and see if those values increase still. If
they do have the line looked at. This is a physical
layer problem. If you want to make sure it's not a
router/internal CSU problem swap your s0 and s1
configs and move the cables if you can take s1 down.
Your s0 config doesn't have the service-module command
specifying the timeslots. By default it should use all
24 timeslots but I have seen this not work correctly
unless you put the command in there.
Also, If you look at the LMI stats you are sending but
not receiving. Is this a new Frame circuit? If so
check with the provider and make sure the circuit is
turned up, have right LMI type, etc. Sometimes they
turn it off to stop the alarms until the customer
installs their equipment.
> ----- Original Message -----
>
> > This is a configuration problem.
> >
> > Situation: I have two ISP's involved. The router
> is a 2500 series.
> > Internal CSU/DSU.
> > On DLCI 17 ISP traffic routes. The other DLCI 16
> doesn't. Information
> > is correct -
> > I must be missing something.
> >
> ====
> >
> > Cormick#show frame-relay map
> > Serial0.16 (down): point-to-point dlci, dlci
> 16(0x10,0x400), broadcast
> > status deleted
> > Serial1.1 (up): point-to-point dlci, dlci
> 17(0x11,0x410), broadcast,
> > IETF
> > status defined, active
> >
> ====
> >
> > Cormick#show frame-relay pvc
> >
> > PVC Statistics for interface Serial0 (Frame Relay
> DTE)
> >
> > DLCI = 16, DLCI USAGE = LOCAL, PVC STATUS =
> DELETED, INTERFACE =
> > Serial0.16
> >
> > input pkts 0 output pkts 4
> in bytes 0
> > out bytes 1794 dropped pkts 0
> in FECN pkts 0
> > in BECN pkts 0 out FECN pkts 0
> out BECN pkts 0
> > in DE pkts 0 out DE pkts 0
> > out bcast pkts 4 out bcast bytes 1794
> > pvc create time 9w3d, last time pvc status
> changed 7w4d
> >
> > PVC Statistics for interface Serial1 (Frame Relay
> DTE)
> >
> > DLCI = 16, DLCI USAGE = UNUSED, PVC STATUS =
> INACTIVE, INTERFACE =
> > Serial1
> >
> > input pkts 0 output pkts 0
> in bytes 0
> > out bytes 0 dropped pkts 0
> in FECN pkts 0
> > in BECN pkts 0 out FECN pkts 0
> out BECN pkts 0
> > in DE pkts 0 out DE pkts 0
> > out bcast pkts 0 out bcast bytes 0
> Num Pkts
> > Switched 0
> > pvc create time 9w3d, last time pvc status
> changed 7w4d
> >
> > DLCI = 17, DLCI USAGE = LOCAL, PVC STATUS =
> ACTIVE, INTERFACE =
> > Serial1.1
> >
> > input pkts 73176244 output pkts 63755322
> in bytes 2986909822
> > out bytes 4214766293 dropped pkts 239
> in FECN pkts 273970
> > in BECN pkts 254655 out FECN pkts 0
> out BECN pkts 0
> > in DE pkts 940978 out DE pkts 0
> > out bcast pkts 96267 out bcast bytes
> 27724896
> > pvc create time 9w3d, last time pvc status
> changed 7w4d
> >
> ====
> >
> > Serial0 is up, line protocol is down
> > Hardware is HD64570 with FT1 CSU/DSU
> > MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
> rely 255/255, load 1/255
> >
> > Encapsulation FRAME-RELAY IETF, loopback not
> set, keepalive set (10
> > sec)
> > LMI enq sent 578802, LMI stat recvd 0, LMI upd
> recvd 0, DTE LMI down
> > LMI enq recvd 0, LMI stat sent 0, LMI upd sent
> 0
> > LMI DLCI 0 LMI type is ANSI Annex D frame
> relay DTE
> > Broadcast queue 0/64, broadcasts sent/dropped
> 4/0, interface
> > broadcasts 2
> > Last input never, output 00:00:04, output hang
> never
> > Last clearing of "show interface" counters never
> > Queueing strategy: fifo
> > Output queue 0/40, 0 drops; input queue 0/75, 0
> drops
> > 5 minute input rate 0 bits/sec, 0 packets/sec
> > 5 minute output rate 0 bits/sec, 0 packets/sec
> > 0 packets input, 0 bytes, 0 no buffer
> > Received 0 broadcasts, 0 runts, 0 giants, 0
> throttles
> > 5210 input errors, 52 CRC, 2 frame, 3
> overrun, 320 ignored, 11
> > abort
> > 578805 packets output, 8105008 bytes, 0
> underruns
> > 0 output errors, 0 collisions, 192612
> interface resets
> > 0 output buffer failures, 0 output buffers
> swapped out
> > 12 carrier transitions
> > DCD=up DSR=up DTR=up RTS=up CTS=up
> > Serial0.16 is down, line protocol is down
> > Hardware is HD64570 with FT1 CSU/DSU
> > Internet address is 216.224.128.66/30
> > MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
> rely 255/255, load 1/255
> >
> > Encapsulation FRAME-RELAY IETF
> > Serial1 is up, line protocol is up
> > Hardware is HD64570 with FT1 CSU/DSU
> > MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
> rely 255/255, load 2/255
> >
> > Encapsulation FRAME-RELAY IETF, loopback not
> set, keepalive set (10
> > sec)
> > LMI enq sent 578763, LMI stat recvd 578758, LMI
> upd recvd 0, DTE LMI
> > up
> > LMI enq recvd 0, LMI stat sent 0, LMI upd sent
> 0
> > LMI DLCI 0 LMI type is ANSI Annex D frame
> relay DTE
> > Broadcast queue 0/64, broadcasts sent/dropped
> 96270/0, interface
> > broadcasts 0
> > Last input 00:00:00, output 00:00:00, output
> hang never
> > Last clearing of "show interface" counters never
> > Input queue: 2/75/29 (size/max/drops); Total
> output drops: 174
> > Queueing strategy: weighted fair
> > Output queue: 0/1000/64/174 (size/max
> total/threshold/drops)
> > Conversations 0/43/256 (active/max
> active/max total)
> > Reserved Conversations 0/0 (allocated/max
> allocated)
> > 5 minute input rate 114000 bits/sec, 23
> packets/sec
> > 5 minute output rate 15000 bits/sec, 23
> packets/sec
> > 73758553 packets input, 2998296891 bytes, 29
> no buffer
> > Received 0 broadcasts, 0 runts, 0 giants, 0
> throttles
> > 187 input errors, 17 CRC, 1 frame, 1 overrun,
> 10 ignored, 11 abort
> > 64337229 packets output, 4222987732 bytes, 0
> underruns
> > 0 output errors, 0 collisions, 2 interface
> resets
> > 0 output buffer failures, 0 output buffers
> swapped out
> > 9 carrier transitions
> > DCD=up DSR=up DTR=up RTS=up CTS=up
> > Serial1.1 is up, line protocol is up
> > Hardware is HD64570 with FT1 CSU/DSU
> > Internet address is 208.184.205.242/30
> > MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
> rely 255/255, load 2/255
> >
> > Encapsulation FRAME-RELAY IETF
> >
> ====
> >
> > Cormick#show config
> > Using 1534 out of 32762 bytes
> > !
> > version 12.0
> > service timestamps debug uptime
> > service timestamps log uptime
> > service password-encryption
> > service udp-small-servers
> > service tcp-small-servers
> > !
> > hostname Cormick
> > !
> > boot system flash 1:c2500-is-l.120-10.bin
> > boot system flash
> > no logging console
> > enable password 7 110A1016141D18
> > !
> > ip subnet-zero
> > no ip domain-lookup
> > clock timezone int 1
> > !
> > !
> > !
> > interface Ethernet0
> > ip address 63.xxx.xxx.158 255.255.255.240
> > no ip directed-broadcast
> > no ip route-cache
> > no ip mroute-cache
> > !
> > interface Serial0
> > no ip address
> > no ip directed-broadcast
> > encapsulation frame-relay IETF
> > no ip route-cache
> > no ip mroute-cache
> > no fair-queue
> > frame-relay lmi-type ansi
> > !
> > interface Serial0.16 point-to-point
> > ip address 216.xxx.xx8.66 255.255.255.252
> > no ip directed-broadcast
> > no ip route-cache
> > no ip mroute-cache
> > frame-relay interface-dlci 16
> > !
> > interface Serial1
> > no ip address
> > no ip directed-broadcast
> > encapsulation frame-relay IETF
> > no ip route-cache
> > no ip mroute-cache
> > service-module t1 timeslots 1-6
> > frame-relay lmi-type ansi
> > !
> > interface Serial1.1 point-to-point
> > ip address 208.x84.xxx.242 255.255.255.252
> > no ip directed-broadcast
> > no ip route-cache
> > no ip mroute-cache
> > frame-relay interface-dlci 17 IETF
> > !
> > router rip
> > version 2
> > network 208.x84.205.0
> > network 208.x85.205.0
> > no auto-summary
> > !
> > ip classless
> > ip route 0.0.0.0 0.0.0.0 208.x84.xxx.241
> > ip route 0.0.0.0.0.0.0.0 216.224.xxx.65
> > !
> > line con 0
> > exec-timeout 0 0
> > password 7 094F471A1A0A04
> > login
> > transport input none
> > line aux 0
> > transport input all
> > line vty 0 4
> > password 7 104D000A061801
> > login
> > !
> > end
__________________________________________________
Do You Yahoo!?
Yahoo! Shopping - Thousands of Stores. Millions of Products.
http://shopping.yahoo.com/
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
