There's not too much to it. HDLC is the default encapsulation, so you won't have to change that. And if the second router you're connecting too has a Cisco internal CSU, they'll have the same default. Basically you just need to put clocking on one of the routers and that should do it. The command is "clock rate ?" (you get to choose the speed - might as well go with the fastest, 4000000).
The commands for configuring your CSU, though, are (in interface config mode) "service-module t1 ?" (get the list). The ones I use most often are:
"service-module t1 timeslots 1-24 speed 64"; this sets the CSU up for 24 channels at 64K per channel (T1 speed)
"service-module t1 linecode b8zs"; B8ZS line coding, as opposed to AMI (your provider can tell you which one to use)
"service-module t1 framing esf"; ESF or SF are your framing choices
Hope that helps. Lemme know if you need something else.
- Don
-----Original Message-----
From: Kelly Scroggins [mailto:[EMAIL PROTECTED]]
Sent: Friday, December 01, 2000 12:35 PM
To: [EMAIL PROTECTED]
Subject: 2610 csu/dsu configuration
Can someone point me to some good documentation on
how to configure the csu/dsu module in a 2610 for
a plain ordinary hdlc t1 connection?
Thanks,
kelly
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
