HI, ISDN is working whith 2 B channels (BRI0:1 and BRI0:2) for DATA and 1 D channel for signalisation (BRI0). To dial to (multiple) location(s), you must use the signalisation channel for the call setup. So it's normal to configure everything on the BRI0. Use n dialer map to specify your n locations you want to dial out to. Jean-Marc -----FW: <[EMAIL PROTECTED]>----- Date: Tue, 5 Dec 2000 21:29:53 -0000 Sender: [EMAIL PROTECTED] From: Aditya <[EMAIL PROTECTED]> To: [EMAIL PROTECTED] Subject: ISDN Channels Config Q? Hi, Im working on a 1603 router. I have to configure DDR using ISDN to two different locations. When I try to go to the interface config mode BRI 0:1 or BRI 0:2 it gives an error message saying "cannot configure the BRI Channels" .. (Im not shure of the exact words, but it meant this). Only BRI 0 works. Can we use Cisco 1600 series for dialing to multiple locations (the channels dialing different locations?). can any one give a bit of explanation on the error messages and solution if any?. Any help will be appriciated. Aditya Kedia Network Engineer. --------------End of forwarded message------------------------- ---------------------------------- E-Mail: Jean-Marc Gilbert <[EMAIL PROTECTED]> Date: 06-Dec-00 Time: 21:01:55 ----------------------------------
|
Hi,
Im working on a 1603 router. I have to configure
DDR using ISDN to two different locations. When I try to go to the interface
config mode BRI 0:1 or BRI 0:2 it gives an error message saying
"cannot configure the BRI Channels" .. (Im not shure of the exact words,
but it meant this). Only BRI 0 works. Can we use Cisco 1600 series for
dialing to multiple locations (the channels dialing different locations?).
can any one give a bit of explanation on the error
messages and solution if any?. Any help will be appriciated.
Aditya Kedia
Network Engineer.
|
