You need to do a 'no int s0/0.2' write mem, reload, then put it back in as a
point-to-point. IOS won't let you change the link type, and you can't just
take the sub-int out and put it back in, you have to reload the router then
re-add it.
Greg
----- Original Message -----
From: "les flack" <[EMAIL PROTECTED]>
Newsgroups: groupstudy.cisco
To: <[EMAIL PROTECTED]>
Sent: Wednesday, December 13, 2000 5:55 AM
Subject: % Warning: cannot change link type
Help,
I have a 3600 @ 11.3 which is running as a frame switch on some ports
and I am trying to configure some of the other ports as routed
point-to-point sub-ints.
But when configuring the second sub int I get the following.
frsw1(config)#int s0/0.1 point-to-point
frsw1(config-subif)#exit
frsw1(config)#int s0/0.2 point-to-point
% Warning: cannot change link type
Which results in the following configuration
interface Serial0/0
no ip address
no ip mroute-cache
encapsulation frame-relay
!
interface Serial0/0.1 point-to-point
no arp frame-relay
!
interface Serial0/0.2 multipoint
no arp frame-relay
Any ideas?
Les
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
