Hi
Just make sure that both the flash SIMMs are the same make either AMD or
Intel if they are different you can't make them one partition.
Regards
Rudolf Venter
CiTEC
-----Original Message-----
From: John Neiberger [mailto:[EMAIL PROTECTED]]
Sent: 29 December 2000 11:24
To: 'ANDERSON, JEFFREY'; [EMAIL PROTECTED]
Subject: RE: Probably A Really Stupid 2500 Series Question
You should check into this, I think he is right. I'm not sure which command
to use in this instance. I'm under the impression that 'no partition flash'
removes partitions, but it may actually be that you need to specify a single
16 meg partition. I think I'll go look that up, it might come in handy
later.
> Yes you have 2 8 meg flash partitions. You could partition the flash into
1
> big 16 meg chinck.
>
>
>
> in config mode do a
>
> partition flash 1 16
>
>
>
>
> -----Original Message-----
> From: ANDERSON, JEFFREY [mailto:[EMAIL PROTECTED]]
> Sent: Friday, December 29, 2000 3:51 PM
> To: '[EMAIL PROTECTED]'
> Subject: Probably A Really Stupid 2500 Series Question
>
>
> Wondering if someone could quickly answer possibly an extremely simple
> question. I haven't had the time to look into this enough so any help is
> greatly appreciated.
>
> I have a couple of 2502 routers I just bought for my lab and was
wondering
> why the flash is configured as follows:
>
> 8192K bytes of processor board System flash partition 1 (Read ONLY)
> 8192K bytes of processor board System flash partition 2 (Read/Write)
>
> I remember see something about partitioning the flash but can't fully
recall
> it now. The routers have 2 slots for flash and both are filled (I assume
> (2) 8s). My question is can I remove both flash partition and
repartition
> as 16MB of Read/Write? These routers where sold as 16MB memory and 8MB
> flash - is there actually 16MB of usable flash?
>
> Again any help is sincerely appreciated.
>
>
> Jeffrey M. Anderson
> MCSE / MCSE+I / CCNA
> SAFECO System Support Unit
> [EMAIL PROTECTED]
>
>
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_______________________________________________________
Send a cool gift with your E-Card
http://www.bluemountain.com/giftcenter/
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
