I'm confused...
I thought that if you had 2 different encapsulations on both ends than it
wouldn't be going up at all, let alone bouncing.
In a message dated 1/15/01 2:07:28 PM Eastern Standard Time,
[EMAIL PROTECTED] writes:
> Most likely....
>
> When we see channels bouncing on our PRIs, we usually
> suspect a telco loop or some switch module issues.
> Sometimes even running through a MUX or framing
> mismatch causes trouble. But if using HDLC solved the
> problem then that probably was the problem... :) You
> guys must both have Cisco boxes on both ends. We
> encapsulate w/ PPP.
>
> --- Frank <[EMAIL PROTECTED]> wrote:
> > when i setup a point to point link with my
> > colleague,
> > my contro e1 0 up and down continuously,at first
> > we thought maybe the physical link's problem,we made
> > local loop and far loop but no result.
> > finally,we found my colleague encap the link with
> > FR,
> > but i encap hdlc.After he changed it to hdlc,all is
> > OK,
> >
> > Is encapsulation difference the reason of this?
> > why?
> >
> > thanks
> >
> > frank
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
