Actually in that example they have the process ID as being 1 and the area ID
is 0 (the backbone). Here's that section of your link you posted:
======================
hostname mollie
!
interface serial 1
ip address 10.0.0.2 255.0.0.0
ip ospf network point-to-multipoint
encapsulation frame-relay
frame-relay map ip 10.0.0.1 201 broadcast
frame-relay map ip 10.0.0.3 202 broadcast
frame-relay map ip 10.0.0.4 203 broadcast
!
router ospf 1
network 10.0.0.0 0.0.0.255 area 0
=================
In a message dated 1/16/01 1:50:15 PM Eastern Standard Time,
[EMAIL PROTECTED] writes:
> Does the OSPF process id have anything to do with its autonomous system
> number? In the sample configuration I found from the Cisco web site
> (http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/np1_
> c/1cprt1/1cospf.htm#xtocid709131), it uses the autonomous system number in
> the 'router ospf' command. I am a little confused.
>
Mark Zabludovsky ~ CCNA, CCDA, 1/2-NP
<A HREF="mailto: [EMAIL PROTECTED]">[EMAIL PROTECTED]</A>
"Even if I knew I had only 1 more week to live, I would still schedule
my CCIE lab. I would just have to work a little harder I guess. After all,
without any goals in life, I'm dead already."
~Mark Zabludovsky~
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
