All networks added under you Dynamic Routing Protocol configuration should
be of local significance only, meaning that they are "connected" to the
router. You should not add networks that are "learned" via RIP. The idea
is to configure the router with the network information that it needs to
"advertise" to other routers in your enterprise. You will also have to run
RIP version 2 if you want to support VLSMs.
Hope this helps a little...
Chris Lemagie
Systems Engineer
Cisco Systems
Seattle Commercial Region
(425) 468-0959
[EMAIL PROTECTED]
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Stuart Laubstein
Sent: Wednesday, January 17, 2001 7:30 AM
To: '[EMAIL PROTECTED]'
Subject: RIP--Network command
I was just doing some RIP configs and realized that I knew how to use the
"network" command but was not really sure how it worked. For instance if
there are three routers a,b,c with major nets 10.1.10.x, 10.1.20.x and
10.1.30.x Each router would need the network 10.1.0.0 correct? Now
supposing router c knew of another major net say the 172.68.x.x through rip
updates Do I need to have the network 172.68.0.0 command on router c or not?
Why? Any clarification on the command would be helpful
thanks
stu
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
