The 2500's are sooo much easier than the 3600's or even the 4000's. You
have the 11.0 boot ROM's (this is good). Just go to the enable mode, config
t, install an IP Address, & copy tftp flash... just as if you had full IOS
(almost)...
Phil
----- Original Message -----
From: "Hubert Pun" <[EMAIL PROTECTED]>
To: "Cisco Study Group" <[EMAIL PROTECTED]>
Sent: Thursday, January 18, 2001 12:13 AM
Subject: boot from ROM
> Hi,
>
> Below is my frame relay switch. It is booting from ROM. The config
> register is still 0x2102. I know that there is xmodem method for 3620.
> However, what should I do for this Cisco 2522?
>
> Thanks
>
> FR-Switch(boot)#sh ver
> Cisco Internetwork Operating System Software
> Cisco Internetwork Operating System Software
> RE (fc1)
> Copyright (c) 1986-1996 by cisco Systems, Inc.
> Compiled Fri 27-Dec-96 17:33 by loreilly
> Image text-base: 0x01010000, data-base: 0x00001000
>
> ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
>
> FR-Switch uptime is 5 minutes
> System restarted by power-on
> Running default software
>
> cisco 2522 (68030) processor (revision M) with 2048K/2048K bytes of
> memory.
> Processor board ID 06198817, with hardware revision 00000003
> X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
> Basic Rate ISDN software, Version 1.0.
> 1 Ethernet/IEEE 802.3 interface.
> 2 Serial network interfaces.
> 8 Low-speed serial(sync/async) network interfaces.
> 1 ISDN Basic Rate interface.
> 32K bytes of non-volatile configuration memory.
>
> Configuration register is 0x2102
>
> FR-Switch(boot)#
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
