I think you answered this yourself. Find out what type of line it is. Is
it a DDS, or T-1 access? That will tell you which mod to use.
tv
----- Original Message -----
From: "David Sanderson" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Wednesday, January 17, 2001 8:40 PM
Subject: WIC Confusion
> My telco has installed a 64K line. I thought I could use a T1 WIC, and
set
> the bandwidth to 64 and/or use the command service-module timeslot 1 to
run
> this point-to-point leased line. Is this only possible if the line is
> fractional T1?(the question probably should be "what is the line, 64K or
> fract. T1) But my telco provider says that the cisco 1602 built-in 56K
> module should be used for this line(the 1602 has a T1 module that I bought
> for this line; and of course the built-in 56K). A Cisco rep. said no, it
> has to be a T1 module. I also have another available module in my 3640
here
> at work that has a 56/64K stamped on the back of the hardware module
itself.
> But when I show int. for that module it says 56K module(bandwidth 1544,
> unless I set it to 64k). Which should I use or can I use either/all if
> configured correctly? Can someone help clear this up? Thanks for any
help.
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
