A lot of older catalyst 5000 blades don't support either trunking or
etherchannel. What is the exact model number of the blade? If it doesn't,
upgrading to a new supervisor won't do anything for you.
-----Original Message-----
From: Jason T. [mailto:[EMAIL PROTECTED]]
Sent: Thursday, January 18, 2001 1:59 PM
To: [EMAIL PROTECTED]
Subject: Hard/software requirement
Hi Group, does anyone know what's the minimum hw/sw requirement to set up a
trunk port? I have a cat5500 with Supervisor Engine I running s/w 3.2(1b) &
a 12-port 10/100BASE-TX Fast Ethernet blade running s/w 3.2(1) connecting to
a FastEthernet on a cisco 7204. I cannot get trunking to work. The switch
doesn't understand "show port capabilities". Do I need a Supervisor Engine
II in order to do trunking? Thanks.
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
