I've always used the exact match mask of 0.0.0.0 to specify interface addresses to
place in the OSPF process. I find this way to be much simpler for config reading
which is helpful during troubleshooting.
-pete
*********** REPLY SEPARATOR ***********
On 1/29/2001 at 6:06 AM David Richard wrote:
>If I want to configure OSPF for my serial interface having Ip-address of
>
>183.23.45.46 255.255.255.224
>
>Am I correct to choose its wild card mask as 0.0.0.31???
>
>
>
>DR.
>
>____________________________________________________________________
>Get free email and a permanent address at http://www.netaddress.com/?N=1
>
>_________________________________
>FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
