My first thought is that your config register is set to ignore the startup
config upon boot. Make sure it is set to 0x2102.
I should mention that we have a 2511 here that exhibits a similar problem,
but only with select portions of the config. If I were to reboot it right
now, the running config would still show all of my dialer in-band statements
and my encapsulation ppp statements. Yet, if you do a show interfaces, they
all will show SLIP as the encapsulation. And, if you make config changes to
the dial backup config, it will report "Must configure dialer in-band first"
or something to that effect.
My solution is to do copy start run after every reboot, or manually type in
those two commands.
HTH,
John
> Hi!
> I have configured 2511 from TFTP server, it runs fine after Loading
config
> from TFTP, but if I reboot it with "RELOAD" command it looses its entire
> content.
>
> I used following sequesnce EXACTLY
> 1. COPY TFTP STAR
> 2. COPY STAR RUN
> 3. COPY RUN STAR
> 4. RELOAD
> Still I got above problem.
> Any solution & cause?
> Thanks a lot in advance.
> Regards
> MK
>
>
> ____________________________________________________________________
> Get free email and a permanent address at http://www.netaddress.com/?N=1
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_______________________________________________________
Send a cool gift with your E-Card
http://www.bluemountain.com/giftcenter/
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
