Hi group, In a hub and spoke frame relay scenario, I set up point to multipoint subinterface at the hub. I then configure a frame map statement for each spoke to its respective dlci. At the spoke, I used physical interface and map the ip address of the hub and another spoke to the same dlsci. To ping the ip address on the local frame relay interface, I configured another map statement on the spoke to map the local ip address to the dlci. I also configured a map statement on the hub to map the local ip address to one of the dlci. These config work fine. I can ping all frame relay interfaces from all routers. I got an advice from a senior CCIE, the above mapping config may cause problem in some situation, but he did not tell me why. I have tried different protocol and with all the combination I can thing of. I can not find any problem. Can anyone in the group see any potential problem in the above config. Thanks FL _________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com. _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
