ramius, do you have no exec configured on the line interfaces? I think
that would cause your symptom
Joe
---- from your link
line 1 16
session-timeout 20
! -- session times out after 20 minutes of inactivity.
no exec
exec-timeout 0 0
! -- exec timeout is disabled. transport input all
! -- allow all protocols to use the line.! -- lines 1 16 must be configured
with at least transport input telnet. flowcontrol hardware
""ramius"" <[EMAIL PROTECTED]> wrote in message
95mia6$gr5$[EMAIL PROTECTED]">news:95mia6$gr5$[EMAIL PROTECTED]...
> I have a 2509 connected via an OCTAL cable to a few console ports. When I
> connect using 'telnet router1 2001' I get no command line, but the
> connection says '.....OPEN'. When I telnet to router1 and configure it,
> console messages appear on the reverse telnet session, but still no
command
> prompt.
> I have it configured just as it is here:
> http://www.cisco.com/warp/public/793/access_dial/comm_server.html
>
> Any help would be greatly appreciated.
>
> thanks,
>
> ramius
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
