Hi,
I had this recently it turned out to be the DCLI number was configured wrong on one of
the routers. The router at one end had several DLCI's the remote end pointed to a
DLCI not belonging to it but one belonging to one of the other services. Therefore
the IP addresses did not correspond.
Just a thought
Teunis
Hobart, Tasmania
Australia
On Tuesday, February 20, 2001 at 09:22:56 AM, Jerry Deer wrote:
> I am having a problem that I'm hoping someone can shed some light on. I have
> a 256k frame relay ckt that if i configure for s0 it will show int s0 up and
> line protocol up but won't allow me to ping int s0's ip address . If I
> configure the frame relay on a sub in s0.1 point-to-point , the s0 will show
> up and up but the s0.1 is down and down. Any clues??? I'm perplexed
>
> _________________________________
> FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
>
--
www.tasmail.com
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
