Hi all !
I am trying to connect win2000 station to cisco 2600 and to use callback. I
get connected, authenticated and
callback doesn`t happen. Station stays connected as if there was no callback
configured on the router. If I remove dialer callback-secure command from
dialer interface, call gets rejected and the "number of incoming call
rejected for callback" under sh dial are incremented. Does anybody have any
sugestions or maybe working config for this situation ? Here is my config:
username test callback-dialstring 123 password xxx
ip subnet-zero
isdn switch-type basic-net3
!
nterface BRI1/1
no ip address
no ip directed-broadcast
encapsulation ppp
dialer pool-member 2
isdn switch-type basic-net3
ppp authentication ms-chap chap
!
interface Dialer3
ip unnumbered Loopback1
no ip directed-broadcast
ip nat inside
encapsulation ppp
dialer remote-name dostop
dialer idle-timeout 100
dialer callback-secure
dialer string 123 class test
dialer caller 123 callback
dialer pool 2
dialer-group 1
peer default ip address pool dostop
ppp callback accept
ppp authentication ms-chap chap
!
ip local pool dostop 192.168.31.1 192.168.31.2
!
map-class dialer test
dialer callback-server username
dialer-list 1 protocol ip permit
---------
Tomaz Klemencic
Hermes Plus, d.d., PE Celje
Kersnikova 19, 3000 Celje
+386-3-4284022
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
