I have scenario to install:
Headquarter (HQ) connect to Branch A (A) and B (B) using Frame Relay
HQ using E&M conect to PABX HQ and Branch A using E&M but Branch B using
FXO.
We make dial plane like this:
x-111-yyy --> to HQ from the rest
x-222-yyy --> to A from the rest
x-333-yyy --> to B from the rest
x = number that user must dial to get the tone from Voip configured in PABX
yyy = local extension number.
The problem is, when we dial from HQ to Branch A/B, we can only reach the
user at the opposite site if we dial x-222-yyy / x-333-yyy all at once. We
can not press x-222 to get the tone from PABX A and then extension number.
How can we configure the router to enable user get the tone from opposite
PABX after dial 111 or 222 or 333.?
CONFIG in HQ
dial-peer voice 1 pots
destination-pattern 111
port 1/0/0
!
dial-peer voice 222 voip
destination-pattern 222...
session target ipv4:192.168.100.1
!
dial-peer voice 333 voip
destination-pattern 333...
ip precedence 5
session target ipv4:192.168.100.5
voice-port 1/0/0
timing percentbreak 50
operation 4-wire
type 5
signal immediate
regards
Grad
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
