Hello Everyone ,
I am facing a problem while configuring RIP on my network , my network
is as follows :
I have two Cisco 2600 series routers which are connected back to back .
1) On the fisrst Router Cisco2610 my configuration is as follows :
Ethernet0/0 11.100.10.1
Serial0/0 200.100.10.1
2) On the second Router Cisco2620 my configuration is as follows :
Ethernet0/0 192.168.1.1
Serial0/0 200.100.10.2
I am able to ping from one end of the ethernet of one router to another
when I configure the routing table statically , but when I am giving the
following commands for dynamic routing on both of the router :
1) on 2610 config) router rip
network 200.100.10.0
2) on 2620 config) router rip
network 200.100.10.0
I am not able to view the RIP (R) entries when I give the command show ip
route , it shows me only all the directory connected interfaces and gives me
a message that gateway not set.
When I give the command show ip Protocols , it shows me that RIP is
running .
I have even changes the network address to the other interfaces
addresses , that the ethernet interface address of the other side of the
other router , but still does not display R on the show ip route command
What could be the error I am making , please let me know .
I am new on routers and switches .
thanks,
Navin Parwal
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
