Hmmm, I think there may be an issue in OSPF (that is if your running that
protocol). Check to see what state OSPF is in on the head end. The link may
be flapping and your just not catching it when it's down. Call the telco
also and tell them of your issues. Hope I help any...
*****************************************************************
This has been an Eyez Only streaming e-mail broadcast...We are watching.
NetEyez - CCNP, CCDA
----- Original Message -----
From: "Shane Stockman" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Monday, March 26, 2001 5:54 PM
Subject: Router problem at remote node
> I have a 1720 with serial wic on a remote branch.I cannot telnet nor ping
> the router even though the router on my side says that both the interface
> and line is up.The guy on the other side can see some routes not all.I
have
> checked the config with him line by line so I know it is not the config ,
> done a clear ip route * ,shut the serial then opened it and much more with
> no luck.On his side it shows the serial and line as up.I figure that there
> could be one of only 2 problems
> 1. The serial wic is a bit stuffed
> 2. IOS is a bit on the blink
>
> Any suggestions would be appreciated.
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
