The 2948G-L3 is for all intensive purposes, a 50 port router. All ports are
L3 ports by default. To use it as a switch, create bridge groups. Each
bridge group is a VLAN. To route between VLAN's use IRB with BVI
interfaces. For Trunk interfaces use sub-interfaces with ISL or dot1q
encapulation and put each sub-interface in the proper bridge group.
There are no "vlan database" commands or "switchport" commands.
Tony Medeiros
#6172
-----Original Message-----
From: Bhupinder Shergill
To: [EMAIL PROTECTED]
Date: Saturday, April 21, 2001 9:22 AM
Subject: Creating Vlan on 2948G-L3 [7:1486]
>I am trying to create VLAN on 2948G; Is there any special command to do
>that on the switch because vlan database command is not there. If anyone
>has done this before, please help me out.
>
>Regards
>
>B
>
>
>_________________________________________________________
>Do You Yahoo!?
>Get your free @yahoo.com address at http://mail.yahoo.com
>FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=1487&t=1486
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
