"Line protocol is down" could have more to do with your IP schemes. change or reenter ip addressing, verify same subnet. go to global conf. and type IP routing. This may not be your fault so much as it is the routers code. Also, down the interface, bring it back up and wait for 120 seconds. Do a sh ip int brief to verify connectivity. Michael L. Lucas CCSI# 22672 "Tariq" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Hello Everybody. > > I am getting very strange problem in my home network. > I am getting Status is up and line protocol is down message. > > Please check the attached diagram. I am unable to coonect Serial 1 of Router > 2 with Serial 1 of router 3 > > I applied clock rate 64000 command on serial 1 interface of Router 2. > Encapsulation on both ends is HDLC. > I changed keepalive but was no success. Default keepalive is 10. > > Cable and interface is is 100% ok thats why status is up. Line Protocol is > down means that there is some problems on datalink layer. > > I think that it could be some masking problem. Please see it and let me > know. > > Thanks > > Tariq > FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=1738&t=1508 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
