I can session into the MSFC module and do "ip nat inside/outside" on the
VLANs. However, I have another router that is connected directly to the
6509 using one of the Fast Ethernet ports of the 6509. The problem is I can
see that port when I am in MSFC IOS. If I telnet directly to the 6509, it
is set-based command....
""Jason Roysdon"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> Catalyst switches don't do layer 3 manipulation. You'd need to do this
sort
> of thing in the MFSC (router) module if your CAT6509 has one. You would
> 'session' into the module from the CLI of the switch if you had one. From
> the MFSC, NAT is going to be identical to an IOS router, as that's what
the
> MFSC is.
>
> --
> Jason Roysdon, CCNP+Security/CCDP, MCSE, CNA, Network+, A+
> List email: [EMAIL PROTECTED]
> Homepage: http://jason.artoo.net/
>
>
>
> ""Thomas"" wrote in message
> [EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> > Hi All - I wonder if NAT is support on set-base IOS? I am trying to use
> > static NAT on the 6509. I could only define "ip nat inside" and "ip nat
> > outside" on VLAN interfaces of the IOS card. Is there a way I can issue
> the
> > "ip nat inside" on the physical swith port of the 6509, just as I could
> with
> > router ethernet ports?? Thanks All.
> > FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=2430&t=2355
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
