Jerry, do a show ver and verify that the config-reg is set correctly. tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Jerry Seven Sent: Tuesday, May 15, 2001 7:48 PM To: [EMAIL PROTECTED] Subject: 2502: Always initial configutation dialog in the boottime [7:4618] Hi Group, I just got a 2502, it runs 10.3(16), I configured it and use "copy run start" to save it, but next time when I boot the box, I still got the initial configuration dialog: --- System Configuration Dialog --- At any point you may enter a question mark '?' for help. Use ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets '[]'. Would you like to enter the initial configuration dialog? [yes]: no I pressed no, then I found everything I configured before reload is not there. "show start" still shows correct config but it's not used, for "show run" gives me blank config. I know the image is quite old, but without solving this problem I couldn't upgrade it. Anyone know what's wrong here? Thanks, Jerry _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=4645&t=4645 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
