Hello, I am having a problem getting my serial ports to act in DCE mode.
I have changed the jumpers to the appropriate places, but still have no
luck. When I issue the "show controller mci" command it tells me that
the interfaces are in DTE mode, except for one, which is recognized as
unknown. I have 4 serial ports. Two are hooked up to one card, and two
to another card. I have changed the jumpers correctly for serial ports 2
and 3( I used the diagram from cisco's website, labeled CSC-SCI, which
looked exactly like the card for serial ports 2 and 3). Here is the link
to the diagram,
http://www.cisco.com/univercd/cc/td/doc/product/core/cisagspl/agscfig/43412.htm#xtocid1591
I
was unable to change the jumpers for serial 0 and 1 because I couldnt
find the jumpers for that card...it kinda looked like CSC-MCI but the
jumpers were not in the same place. I have tried to issue the "clockrate"
command on all serial interfaces but it says I cannot because it is in
DTE mode. I am stuck at this point. Does it have to do with the
microcode on each controller? Do I need to upgrade this? Any help would
be appreciated immensely!!!! Paul
------------------------------------------------------------------------
Get your FREE download of MSN Explorer at http://explorer.msn.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=4655&t=4655
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
