Hello Engineers,
Could some one please figure out why I could not apply a named extended ip
access to the pos interface below. The router does not give me the option to
apply the access list to the interface.
Thanks
GSR#show access-lists
Extended IP access list inboundfiler
deny icmp any any
permit ip any any
GSR#
GSR#config t
Enter configuration commands, one per line. End with CNTL/Z.
GSR(config)#int pos1/0
GSR(config-if)#ip acc
GSR(config-if)#ip access-group ?
IP access list (standard or extended)
IP expanded access list (standard or extended)
GSR(config-if)#^Z
GSR#
03:58:56: %SYS-5-CONFIG_I: Configured from console by console
GSR#
GSR#show ip int b
Interface IP-Address OK? Method Status
Protocol
POS1/0 10.10.0.2 YES manual up up
POS1/1 10.10.1.2 YES manual up up
POS1/2 10.10.2.2 YES manual up up
POS1/3 10.10.3.2 YES manual up up
GigabitEthernet11/0 10.10.200.1 YES manual up up
GigabitEthernet11/1 unassigned YES unset administratively down down
GigabitEthernet11/2 unassigned YES unset administratively down down
Ethernet0 unassigned YES unset up up
GSR#
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=5830&t=5830
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
