it's good stuff when troubleshooting atm. gives you clokc source and what
type of errors you are receiving
>>> "Watson, Rick, CTR, OUSDC" 06/14/01 11:09AM >>>
...reading the Cisco Press Support Book. They talked about the 'show
controllers' command. My question is when and why would you use this
command? I read that the output can be overwhelming, and that some of the
information is irrelevant! Go figure!. But again, when would you need the
information form this command? Thanks for the insight.
Rick Watson
Network Engineer
Advanced Systems Development, Inc.
OUSD(Comptroller)
703.697.5710 office
[EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8545&t=8528
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
