I'm struggling with similar issues myself, so feel incompetent at this
point ... however, it looks to me like the reason the line does not
disc. when you have the broadcast param is that your ipx rip is
considered interesting traffic. I think you need to add the access-list
915 you defined to your dialer-list ....
access-list 915 deny 0 any all any 457
access-list 915 deny rip any rip any rip
access-list 915 deny sap any sap any sap
access-list 915 permit any any all any all
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx list 915
Jason
Circusnuts wrote:
>
> Hey all- I'm trying to get Snap Shot Routing "up" on an ISDN link. I spent
> most the morning with it & checked the CCO's Open Forum many times.
> Basically- I cannot get IPX RIP updates to cross the BRI, for route table
> updates. Snap Shot is doing it's part, opens & closes @ the specified
times.
> If I allow the "broadcast" statement in the "dialer map," this of course
> fixes
> the routing table update issue... but BRI never goes down (semi obvious
> reaction :o) I've found very little information dealing with the mechanics
> of
> Snap Shot, except for configs.
>
> If anyone can please take a glance @ the configs for me, I would be very
> appreciative of any suggestions !!!
> http://www.geocities.com/circusnuts_1999/SnapShot.htm
>
> Thanks !!!
> Phil
--
Jason Douglas
Lucent World Wide Services
Pager 888-451-0755
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=8612&t=8609
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
