first define an acl permitting the ips of both points. Then use the "deb ip
packet"
command.
Example:
point to point from 192.168.1.1 to 192.168.1.2
router2#conf t
Enter configuration commands, one per line. End with CNTL/Z.
router2(config)#access-list 90 permit 192.168.1.0 255.255.255.252
router2(config)#exit
router2#debug ip packet detail 90
IP packet debugging is on (detailed) for access list 90
Raees Ahmed Shaikh escribis:
> Dear Friends,
>
> Can anybody suggest some parameters about debug, I want to check the ip
> traffic details between two point to point connections only, which options
> from the debug command should I used, I just want to know the traffic flow
> between two ppp points, there might be more serial and Ethernet connections
> available on the router.
>
> Any help appreciated.
>
> Thanks
--
Este e-mail puede contener informacisn confidencial y/o privilegiada. Si
usted no es el destinatario final del mismo (o si ha recibido este e-mail
por error) por favor notifmquelo al remitente inmediatamante y destruya este
e-mail. Cualquier copia, modificacisn o propagacisn no autorizadas del
contenido de este mensaje esta estricatamente prohibida.
This e-mail may contain confidential and/or privileged information. If you
are not the intended recipient (or have received this e-mail in error)
please notify the sender immediately and destroy this e-mail. Any
unauthorised copying, disclosure or distribution of the material in this
e-mail is strictly forbidden.
Diese E-Mail enthdlt vertrauliche und/oder rechtlich gesch|tzte
Informationen. Wenn Sie nicht der richtige Adressat sind oder diese E-Mail
irrt|mlich erhalten haben, informieren Sie bitte sofort den Absender und
vernichten Sie diese Mail. Das unerlaubte Kopiere
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=10633&t=10598
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
