Yes, I have seen that some routers has to have NONE in flow control instead
of HARDWARE. I have four routers, but in order for me to talk with all four
via my console cable, I have to configure my Hyper Terminal with
9600,N,8,1,NONE. If I set it to 9600,N,8,1,HARDWARE, I can only talk with
three of them (?????).
Also, be sure to connect it to the CONSOLE port and not the AUX.
Hth,
Ole
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Ole Drews Jensen
Systems Network Manager
CCNA, MCSE, MCP+I
RWR Enterprises, Inc.
[EMAIL PROTECTED]
http://www.oledrews.com/ccnp
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NEED A JOB ???
http://www.oledrews.com/job
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-----Original Message-----
From: Dennis Laganiere [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, July 10, 2001 10:05 PM
To: [EMAIL PROTECTED]
Subject: Dead 2501 [7:11865]
I just got a 2501 off of ebay and it seems to boot up OK, but it won't
accept any commands from the keyboard. The console speed is right,
otherwise I wouldn't be able to see the boot process. I was able to issue a
control-break and it started at the ">" prompt, but even there, no keyboard.
I hooked up another router to the console cable to make sure it wasn't the
PC, but that router worked fine.
Any ideas?
--- Dennis
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=11868&t=11865
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
