You can look at load, but u may want to check your cable
and CSU setting. And you could run a debug lmi and sh
frame lmi to seen the state of your frame-relay.
> Hello,
> If I have a frame relay switch which is being over utilized will that cause
> the connection to drop. After looking in the log I see dlci 501 state
> changed
> to inactive, line protocol on interface s0/0.1 changed to down, dlci 501
> active, this keeps going and going through out the log. The local telco
> insists that the circuit is overutilized and this is why the connection is
> dropping. I think it is a telco or csu problem. Also doing a show
interface
> is showing 3000 crc errors and 500 interface resets for the past 3 days.
Is
> there any way to tell for sure whether it is overutilization or a telco
> problem??
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=13359&t=13349
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
