I have a hub and spoke combination going without any problems. But the only
weird thing happening is that on my Frame-Relay switch (2522), I have to set
the "frame-relay intf-type" to DCE for all the serial interfaces I'm using,
otherwise the layer 2 connections won't come up on the hub and spoke routers.
Should this be happening?
I have 3 DTE ends and 1 DCE end of cables plugging into my switch. I thought
if I had the DTE side of the cable plugged into my S0 of my frame relay
switch, then on the interface configuration mode for "S0", I would specify
the
intf-type to be DTE. And vice versa if the DCE side of the cable is plugged
into my switch.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=14434&t=14434
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
