When using a BRI for backup on a Frame-Relay circuit, the "backup load 70 30" command goes on the primary serial interface(S1) while the "backup int BRI1" command and the "backup delay 30 60" command are on the sub-interface(S1.1). My question is this: when you have more than one Frame sub-interface going to different locations, and the second sub-interface(S1.2) does not utilize a backup BRI, but this second sub-int(S1.2) connection loads the circuit(S1) to over 70% utilization, does BRI1(which is only backing up S1.1) come up due to the 70% utilization of serial 1? If so, is there some command to work around this problem that I'm missing, or is it just not possible to use the 'backup load" command when the backup interface is only on one subinterface? Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=15373&t=15373 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
