Okay.... here's the deal. Got a 7513 with dual RSPs (in slots 6 & 7).
Can't remember offhand if they're RSP2 or RSP4 or what, but they're the
same. I can pull one RSP (either one), turn the unit on, and it boots up
into the IOS fine (IOS 12.1.9). However, if I put them both in and boot up,
the one in slot 6 becomes the master (normal) but then I start getting these
messages on the console saying that the RSP in slot 7 is changing from Slave
to Non-Participant, then back from Non-Participant to Slave, over and over
and over. When I do a "show bootvar" it only shows the boot variables for
the Master RSP and says that the slave is offline (or not there).
Both RSPs have the same boot helper file, IOS image, and config file.
I've searched Cisco's site and Cisco only has 3 documents that even contain
the word "non-participant" and none of them pertain to this situation.
Any ideas?
TIA,
Mike W.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=15461&t=15461
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
