You would need to configure one of the routers to act as a frame relay
switch.
This is a good article on how to convert a router into a frame relay switch,
and a setup...
Watch the wrap:
http://www.cisco.com/warp/public/125/fr_switching.html
HTH,
Eric
-----Original Message-----
From: george gittins [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, August 15, 2001 1:10 PM
To: [EMAIL PROTECTED]
Subject: subinterfaces with v.35 [7:16202]
can you make subinterfaces with v.35 back to back , i tried and no success
shows the line down , works with point to point dough, any suggestions?
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=16203&t=16202
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
