-If you think the config change made the mess, try to boot with slot 4
removed.
-Also, are you using the right break key for your hyperterminal? (here is
the link for the break key sequence.
http://www.cisco.com/warp/public/701/61.html
)
*** I thought the correct stop bit was 1 instead of 2.
9600 baud rate
No parity
8 data bits
1 stop bit ( you said yours is set at 2)
No flow control
-If your keyboard is not working at all, your register might have been
changed.
Can you telnet in or use your AUX port?
Let me know if these helps.
Ed
CCNP, CCDP
-----Original Message-----
From: Richard Chang [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, August 22, 2001 12:58 AM
To: [EMAIL PROTECTED]
Subject: Help! Locked out of my 7513 Router! [7:16769]
Dear Cisco Groupstudy Person:
I locked myself out of my Cisco 7513 router somehow.My Keyboard has no
effect. I'm not sure if this is the reason, but my most recent configuration
change was to fill the No. 4 slot, previously blank, with a Fast Ethernet
Card.
Everytime I power cycle the router, it comes up again, goes through the
boot sequence, and then freezes with a string of messages concerning the
status of FE 3/0 and FE 4/0, first stating that they are up and then stating
they are down.
Even the password recovery technique where one uses the "Break" or "^["
Keys and then resets the Config Register can't be used. For some reason, the
keyboard won't even work; it has no effect in this situation suddenly!!.
I have carefully checked my Hyperterminal settings of 9600 baud ; Data
bits=8 Parity=none stop bits=2 Flowcontrol=none
Anybody have any idea why my keyboard is "dead" I am working with Vlan
configurations on this Router. Please help! Thank you.
*****************************************************************
DISCLAIMER: The information contained in this e-mail may be confidential
and is intended solely for the use of the named addressee. Access, copying
or re-use of the e-mail or any information contained therein by any other
person is not authorized. If you are not the intended recipient please
notify us immediately by returning the e-mail to the originator.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=16772&t=16769
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
