According to very recent studies (this morning on the train in fact), Trunking is only supported on Fast Ethernet and Gigabit Ethernet interfaces. Symon ------------------- > As far as I know, trunking MUST be on at least a fast ethernet interface. > Another way out is put an NM-1E ethernet module on your 2610 and put each > interface in a different vlan. Or buy a 2620. > > I hate to say this, but, this has been gone over AT LENGTH over the last > few months. > > Sorry to be the bearer of bad news. > Tony > > ----- Original Message ----- > From: "Hamid" > To: > Sent: Wednesday, August 22, 2001 1:28 AM > Subject: Problem Using external routers to route between VLANs [7:16781] > > > > Hi group, > > > > I was wondering if it is A MUST for the external routers's interface to be > a > > 100Mb interface, is it possible to do the InterVlan routing on an ethernet > > port (10Mb) on a 2600 router? > > > > I tried to setup a simple scenario with my 2600 router in my home lab, > > setting the port connected to the 2600 router to TRUNK mode with isl > > encapsulation , and allowing all vlans. But when I tried to confgure the > > router's sub-interfaces I the following errors: > > > > Router3(config)#int ethernet 0/0.2 > > Router3(config-subif)#ip address 10.10.2.1 255.255.255.0 > > > > Configuring IP routing on a LAN subinterface is only allowed if that > > subinterface is already configured as part of an IEEE 802.10, IEEE 802.1Q, > > or ISL vLAN. > > > > The other problem was that inthe SUBIF configuration mode I didn't have > the > > ENCAPSULATION command available. > > > > Bellow is the output of the show version command: > > Router3#sh ver > > Cisco Internetwork Operating System Software > > IOS (tm) C2600 Software (C2600-IO3-M), Version 12.2(3), RELEASE SOFTWARE > > (fc1) > > Copyright (c) 1986-2001 by cisco Systems, Inc. > > Compiled Wed 18-Jul-01 17:11 by pwade > > Image text-base: 0x80008088, data-base: 0x809C818C > > > > ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1) > > > > Router3 uptime is 6 hours, 3 minutes > > System returned to ROM by reload > > System image file is "flash:c2600-io3-mz.122-3.bin" > > > > cisco 2610 (MPC860) processor (revision 0x203) with 28672K/4096K bytes of > > memory. > > Processor board ID JAD04390FCB (93659888) > > M860 processor: part number 0, mask 49 > > Bridging software. > > X.25 software, Version 3.0.0. > > 1 Ethernet/IEEE 802.3 interface(s) > > 2 Serial(sync/async) network interface(s) > > 32K bytes of non-volatile configuration memory. > > 8192K bytes of processor board System flash (Read/Write) > > > > Configuration register is 0x2102 > > > > > > Any idea what the problem is? > > > > Thanx in advance > > > > Hamid [EMAIL PROTECTED] > Cheers, Symon Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=16789&t=16789 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
