You have to shutdown vlan 1 first. After that, VLAN 2 should come up fine.
Rob
"Wilson, Christian" @groupstudy.com on
08/22/2001 05:58:15 PM
Please respond to "Wilson, Christian"
Sent by: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
cc:
Subject: 2924xl-en management interface [7:16899]
I have a 2924xl-en switch that has been erased and reloaded, all the VTP
and
VLAN settings are at default. When I assign an IP address to VLAN 2, the
command is taken but the interface will not come up, even after issuing a
no
shutdown command. I am trying to put the management interface in a
different vlan like you would on a cat 5000 series. Does VLAN 1 have to be
used as the mgmt interface on a 2924xl-en??
The information transmitted is intended only for the person or entity to
which it is addressed and may contain confidential and/or privileged
material. Any review, retransmission, dissemination or other use of, or
taking of any action in reliance upon, this information by persons or
entities other than the intended recipient is prohibited. If you received
this in error, please contact the sender and delete the material from any
computer.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=16900&t=16899
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
