To be sure your roll-over cable works, try another one.If it does not, try
with a straight through cable. Some Cisco routers work this way.
If you still experience problems, check your Hyperterminal config to be 9600
etc...
It is also possible that the speed has been setup at a lower or higher speed
in the concole port of the router (config-register value).
Also, if you have a BRI interface, maybe someone plugged the CAT 5 cable
coming from an NT1 into the console port, and in this case...
Regards.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=16923&t=16844
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
