Number one rule of troubleshooting is to change one thing at a time. Looks
like we have four variables. BootROM, Flash, DRAM, and IOS image.
I seem to remember that if you put two sticks of 8MB Flash in a 2500 it will
see it as 16. You have to explicitly create a single partition. If you
don't, you can still copy an image to it; but it is unhappy at reboot. Check
for the particulars on CCO.
Try going back to rommon to change your config register to 0x2141 so you'll
come up in router(boot). Check out your flash parameters.
Try show flash summary
or show flash all
from config t
router(boot)#partition flash ...
> -----Original Message-----
> From: Thomas N. [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, August 23, 2001 9:11 PM
> To: [EMAIL PROTECTED]
> Subject: Configure Register on Cisco 2500 router - urgent! [7:17087]
>
>
> Hi All,
>
> Cisco 2500 have the factory-default setting of 0x2102 for the
> register.
> This will boot from the IOS image on the flash WITH the
> configuration on the
> NVRAM. I wonder what other value I can use beside this 0x2102?
>
> My original problem was that I just upgraded the IOS for this
> Cisco 2500
> router. The upgrade was successfully. I got the correct
> checksum. The
> register setting was then changed back t the factory-default
> 0x2102 (changed
> to 0x2141 for booting from Boot mode to upgrade the image).
> However, when I
> rebooted the router, the router kept reseting itself. I
> wonder if there is
> any other value beside 0x2102 that I can use for the
> register to let the
> router boot from the flash with the configuration? The
> router was also
> hardware upgrade with:
>
> - Boot ROM = 11.0(10c)
> - 16MB flash
> - 16MB memory
>
> The new IOS image is IP/H.323 version 12.2(1)
>
> Thomas N.
> Report misconduct
> and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=17092&t=17087
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
