type ip ospf network point-to-point on the loopback interface. This will
then make ospf send the correct subnet mask
-----Original Message-----
From: Grad Alfons Kanon [mailto:[EMAIL PROTECTED]]
Sent: 31 August 2001 13:31
To: [EMAIL PROTECTED]
Subject: TO SUMMARIZE LOOPBACK IN OSPF [7:18064]
Hello all,
I configure loopback interface with /24 ip address, buat when I put into the
ospf area, I only see the route /32. I tried to use AREA XX RANGE command,
but still failed,
any idea how to enable this route bcome /24 ..?
regards
Grad
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=18074&t=18064
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
