Thomas,
The CAT OS and the IOS on the MSFC's can be upgraded independently in the
6500s. You can reset just the MSFC. I log into the MSFC and enter the
'reset' command while in enable mode. This resets just the MSFC and thus
reduces the down time.
Ed
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Thomas N.
Sent: Friday, August 31, 2001 5:30 PM
To: [EMAIL PROTECTED]
Subject: Reseting Supervisor Engine and/or MSFC [7:18138]
Hi All,
My 6509 has dual Supervisor Engines and dual MSFC cards. It runs in Hyrid
mode. I plan to upgrade the IOS of the MSFC cards only, NOT the Supervisor
Engines. I wonder:
1. Is IOS version of MSFC dependent on the CATOS version of Supervisor
Engine?
2. When I reset after the upgrade, do I have to reset the whole module
(Supervisor Engine + MSFC) or just the MSFC? If I cannot reset only the
MSFC, in what mode should I issue the reset command? CATOS or IOS in this
case (IOS is in session 15 or 16)? Will this reset both the Supervisor and
the MSFC?
3. Should I not losing the configuration which I assumed they're saved in
NVRAM of the MSFC or Sup. Engine?
Again, Thanks much to All!!!
Thomas N.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=18142&t=18138
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
