At this point, it think it would be good to mention that (IMHO) it's best to
use the LoopBack interface for ip unnumbered because it can never go
down......
In the config snipet you gave, your Serial0 couldn't communicate if
FastEthernet0 went down.
I do believe that with some version of 12.x, however, Cisco has made it so
that even if the interface goes down, the unnumbered interface can still use
it's IP, so be sure to check your IOS version, and see if that's the
case...... But, that's just another good reason to use LoopBack because
then you don't have to worry about that...... =)
Mike W.
"Brett Hairbottle" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> Hi
>
> Instead of using a "numbered link" you can use ip unnumbered to connect
> sites.
> Example:
>
> Router A:
> interface fastethernet 0
> ip address 10.100.2.1 255.255.255.0
> interface serial 0
> ip unnumbered fasthethernet 0
>
> Router B:
> interface fastethernet 0
> ip address 10.100.31 255.255.255.0
> interface serial 0
> ip unnumbered fasthethernet 0
>
> now instead of assigning a ip address to each serial port you can use the
ip
> unnumbered command
>
> Brett Hairbottle
> Network Administrator
> CCNA
> ----- Original Message -----
> From: "sami natour"
> To:
> Sent: Sunday, September 02, 2001 10:33 PM
> Subject: IP unnumbered [7:18250]
>
>
> > Hello everybody,
> > I know how to cinfigure IP unumbered but I do not know
> > any practical scenario that I make use of this
> > feature.Any body has specific scanrios where I can
> > use ip unnumbered .
> >
> > Regards ,
> > sami
> >
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Get email alerts & NEW webcam video instant messaging with Yahoo!
> Messenger
> > http://im.yahoo.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=18509&t=18250
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]