I have a 2610 as one peer router and a 3640 as the other peer router. I
have a 7206 operating as the "frame relay switch" between them. Layer 2
and Layer 3 are fine because if I use static routes on both peers I can
ping across the links. However, I must be setting up OSPF dynamic routing
incorrectly. Most examples show OSPF over "point-to-point" frame relay by
running OSPF routing processes on all three routers and then putting the
appropriate network statements on the central router, however the central
router is only a frame-relay switch in my topology without ip addresses on
its interfaces. Any ideas would be helpful.
John Squeo
Technical Specialist
Papa John's Corporation
(502) 261-4035
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=19577&t=19577
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
