Let me rethink that one....
change the interface type with the ospf interface command to non-broadcast
and use a neighbor statement to select the router on the multi-access
segment you would like to form and adjacency with.
-----Original Message-----
From: Jim Brown [mailto:[EMAIL PROTECTED]]
Sent: Thursday, September 13, 2001 3:33 PM
To: [EMAIL PROTECTED]
Subject: RE: filtering ospf [7:19856]
How about a passive interface with a neighbor statement. Changes the
behavior from multicast to unicast, thereby eliminating traffic to the rouge
router.
-----Original Message-----
From: Patrick Ramsey [mailto:[EMAIL PROTECTED]]
Sent: Thursday, September 13, 2001 3:06 PM
To: [EMAIL PROTECTED]
Subject: filtering ospf [7:19856]
Anyone remember how to ACL ospf?
basically I have area 0 on one interface of a router that touches another
company's area 0 (we're splitting) And I want to stop sending them updates
and stop receiving updates from them.
The real kicker is that I still have another router on that side in area 0
that WAS vendor supported and I can not make any changes to it. (therefor
area 0 must remain for it to communicate properly)
I seem to recall reading about filters designed just for this scenario but I
can not find them in conf t.... Anyone else know?
-Patrick
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=19871&t=19856
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
